Intermezzo - Cutting the clear parts

The clear parts, easily got cracked when cut directly from the sprue although already use sharp cutting pliers.

I usually use this method :


First, make scratches around the sprue that hold the parts.
As far as possible from the parts

Then cut with cutting plier.

Here is the result.

To cut the remaining sprue, make several scratches around the remaining sprue.
Be careful by not putting strong pressure on it - I had experienced a crack when I lose control on the pressure.
(some friends use PE saw).

Then. cut with cutting pliers.

For finishing, I usually use sandpaper no. 1000.

It will be good if the parts can be placed on soft base that adhere the contour of the parts.